Takagisan has been quite busy. Here's the 411 for a successful Zed Blade conversion!
The sacrificial host cartridge for this project
is Super Sidekicks 2. No big loss there... heheh.. Transfer the "V"
and "P", "C" M1 and S1 chips to their appropriate locations
on the host boards. The circuit boards are clearly marked so just take
your time and put them in the right chip locations.
Ok, now onto the jumper settings for each board. Ready? Good! Here goes...
You'll only need to make jumper modifications to the CHA256B board. Here are the correct settings:
J1 off
J2 on
J3 on
J4 off
J5 off
J6 off
J7 on
J8 off
J9 off
J10 on
J11 off
J12 off
J13 off
J14 off
J15 off
J16 off
J17 off
J18 off
J19 on
J20 off
Note: Jumper on / off example... 
-- Tiptonium Out...
|
