Here's another great little conversion project from sonof x51.
The sacrificial host cartridge for this project
is Fatal Fury 3 . Transfer the "V"
and "P", "C" M1 and S1 chips to their appropriate locations
on the host boards. The circuit boards are clearly marked so just take
your time and put them in the right chip locations.
Ok, now onto the jumper settings for each board. Ready? Good! Here goes...
The jumpers listed are set to on. The rest are off. PROGBK1Y (these are on)
J1
J9
J13
JB3
Jv5
Jv6
Jv11
CHA256RY (these are on)
J2
J3
J9
J10
J11
J16
Note: Jumper on / off example...
-- Tiptonium Out...
|
