September 2004

Flip Shot Project

Looking for an easy MVS to home format conversion project that is free of the messy jumper setting changes? Want to try your hand at doing a conversion using a cheap SAC cartridge? Want a home version of Flip Shot and you've got the MVS version that is just ripe for a conversion project? Well, if your answer was yes to these questions then here you go.

Remove the V, P, S, M, and C chips from the Sacrifice NGH boards. The sacrificial home cart for this project is Samurai Shodown II.
Remove the V, P, S, M and C chips from the Flip Shot MVS cartridge. Place them in their corresponding locations on the sacrifice NGH boards. Solder them up nice and clean, take your time. Congratulations, you're done.  

Dragonfly was lucky enough to find a cheap, loose Flip Shot MVS cartridge. Apparently, the parts for this project only set him back about $35! Now that's a hot bargain.

The details relating to this project were sent to us at Tiptonium.com by Dragonfly